IP65 100A 4 Pole Stainless Steel Enclosed Multi Position Rotary
Kripal is the ONLY ONE MANUFACTURER of Stainless Steel Enclosed isolators in China mainland.
Switch Disconnectors (Rotary Isolator Switch) provide the means to
safely disconnect or isolate an item of electrical equipment from
the power supply - primarily designed to provide a means of local
isolation when an electrical item may need maintenance or repair.
Switch Disconnectors also
i) provide an effective clearance between the supply and the
electrical load appropriate to the voltage applied,
ii) provide a means of "locking off" (padlocking),
iii) provide true indication of contact state,
iv) provide a safe electrical disconnection from the power supply
even under fault conditions.
No. of poles
No. of layers
make as required with circuit diagram
color of handle
≤50% with highest temperature +40°C,but allow higher humidity with
low temperature less than 40°C
(eg.: humidity 90%----teperature20°C)
pollution class III
The rotary isolator switch disconeectors must be selected according
to the following performance specifications:
1) According to motor switching capacity, when the switch is fitted
in such a way that the operator may use it for operational ON and
2) The rating data always applies to 3 poles. When the motor rating
is divided between 6 poles, such as for star-delta switching, a 6
pole switch can be used to control 1.73 times the rated power.
3) If the rotary isolator switch has a load-shedding Contact (LA),
you can select the appropriate switch according to the
uninterrupted current. The load-shedding contact is an auxiliary
contact, which s closed in the ON position and opens early when
witching off, so that a contactor located in the circuit takes over
the switching duty and the maintenance/safety switch operates at
zero load. When switching on, the load-shedding contact closes
later than or at the same time as the main contacts.
• Safety switches are always housed in insulated enclosures and
have an inscription saying "Safety Switch" on a bright orange
• Switches to be used for emergency stop switching have a red
handle and yellow locking collar in accordance with STOP category O
(as per IEC/EN 60204/VDE 0113).
• If the switch is not approved for emergency stop switching, both
parts will be black
• The cover and handle are interlocked by fitting a padlock.
a. Netural contacts
b. 1NO+1NC module
c. Color of handle and surroundings
Important safety notice
It is the responsibility of the person installing the electrical
equipment to ensure that the installation meets the requirements of
the IET wiring regulations and is therefore ‘fit for purpose'.
Factors such as correct selection of components, cable sizing,
protective devices and Earth bonding are all critical and should be
checked prior to full testing and power-up. Any other regulations
applicable to the equipment being installed such as the Machinery
Directive and current health and safety legislation must also be
adhered to. Terminals, including factory fitted, should be checked
periodically to ensure correct tightness.